Cisco Cisco ASR 5700

Page of 8994
ACS Rulebase Configuration Mode Commands   
▀  billing-records 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
648 
   
billing-records 
This command allows you to configure the type of billing to be performed for subscriber sessions. 
Product
 
GGSN 
P-GW 
SAEGW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > Rulebase Configuration 
active-charging service service_name > rulebase rulebase_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-rule-base)# 
Syntax
 
billing-records { egcdr | radius | rf | udr udr-format udr_format_name [ failure-
handling-udr-format 
udr_format_name ] } + 
no billing-records 
no
 
If previously configured, deletes the billing-records configuration from the current rulebase. 
egcdr
 
Generates an enhanced G-CDR (eG-CDR) for GGSN / P-GW-CDR for P-GW, and/or UDR with specified 
format on the occurrence of an interim trigger condition at the end of a subscriber session, or an SGSN-to-
SGSN handoff. 
radius
 
Generates postpaid RADIUS accounting records at the start and end of a subscriber session, and on the 
occurrence of an interim trigger condition. RADIUS accounting records are generated for each content ID. 
Important:
  In the GGSN, if in the APN configuration the “accounting-mode” is set to “none”, the system 
continues to send ACS-generated RADIUS accounting messages. In the PDSN, if in the subscriber default configuration 
the “accounting-mode” is set to “none”, the system does not send any RADIUS accounting messages (including ACS 
accounting messages). 
rf
 
Enables Rf accounting. 
Rf accounting is applicable only for dynamic and predefined rules that are marked for it. Dynamic rules have 
a field offline-enabled to indicate this. To mark a predefined rule as offline-enabled, use this keyword and the 
billing-action
 command in the ACS Charging Action Configuration Mode.