Cisco Cisco ASR 5700
WSG Service Configuration Mode Commands
▀ responder-mode-duration
▄ Command Line Interface Reference, StarOS Release 17
8994
responder-mode-duration
Specifies the interval during which the WSG service (SecGW) will wait for a response from an IKE peer before
switching to initiator mode. A peer list must be configured in this WSG service for this command to be available (VPC
only).
switching to initiator mode. A peer list must be configured in this WSG service for this command to be available (VPC
only).
Product
SecGW (WSG)
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > WSG-Service Configuration
configure > context context_name > wsg-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-wsg-service)#
Syntax
responder-mode-duration seconds
default responder-mode-duration
default
Sets the responder mode duration to 10 seconds.
seconds
Specifies the duration interval in seconds as an integer from 5 through 250.
Usage
Use this command to specify the interval during which the WSG service (SecGW) will wait or a response
from an IKE peer before switching to initiator mode (default is 10 seconds).
This command is only available when a peer-list has been configured for the WSG service.
See the IPSec Reference for additional information on configuring an SecGW as an IKE initiator.
from an IKE peer before switching to initiator mode (default is 10 seconds).
This command is only available when a peer-list has been configured for the WSG service.
See the IPSec Reference for additional information on configuring an SecGW as an IKE initiator.
Example
The following command sets the responder mode duration to 15 seconds:
responder-mode-duration 15