Cisco Cisco ASR 5700

Page of 8994
ACS Ruledef Configuration Mode Commands   
▀  ip src-address 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
960 
   
ip src-address 
This command allows you to define rule expressions to match the source IP address field within IP headers. 
Product
 
ACS 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > Ruledef Configuration 
active-charging service service_name > ruledef ruledef_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-acs-ruledef)# 
Syntax
 
[ no ] ip src-address { operator ipv4/ipv6_address ipv4/ipv6_address/mask } | { 
!range | range } host-pool 
host_pool_name } 
no
 
If previously configured, deletes the specified rule expression from the current ruledef. 
operator
 
operator
: Specifies how to match. 
operator
 must be one of the following: 
 
!=
: Does not equal 
 
<=
: Lesser than or equals 
 
=
: Equals 
 
>=
: Greater than or equals 
ipv4/ipv6_address
 
Specifies IP address of the source node for incoming traffic. 
ipv4/ipv6_address
 must be an IP address in 
IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation. 
ipv4/ipv6_address/mask
 
Specifies the IP address of the source node for incoming traffic with subnet mask bit. 
ipv4/ipv6_address/mask
 must be an IP address in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal notation with subnet mask bit. The mask bit is a numeric value which corresponds to the number 
of bits in the subnet mask. 
{ !range | range } host-pool host_pool_name
 
!range | range
: Specifies the range criteria: 
 
!range
: Not in the range of 
 
range
: In the range of