Cisco Cisco Packet Data Gateway (PDG)
Policy Control Configuration Mode Commands
▀ associate
▄ Command Line Interface Reference, StarOS Release 17
7974
dual-mode
: This keyword enables both PCRF and local-policy to work together. When this CLI command is
enabled, for a few set of events, PCRF will be contacted and for a few local-policy will be contacted.
This keyword is configured to provide load balancing support for PCRF, and failure-handling support when
PCRF is down or any failure is detected.
By default, the
This keyword is configured to provide load balancing support for PCRF, and failure-handling support when
PCRF is down or any failure is detected.
By default, the
dual-mode
keyword will not enabled and only on PCRF failure the local-policy will be
contacted.
For more information on local policy service configuration, refer to the
For more information on local policy service configuration, refer to the
local-policy-service
command
in the Global Configuration Mode Commands chapter.
Usage
Use this command to associate a configured failure handling template or local policy service with the IMS
authorization service.
The failure handling template defines the action to be taken when the Diameter application encounters a
failure supposing a result-code failure, tx-expiry or response-timeout. The application will take the action
given by the template. For more information on failure handling template, refer to the Failure Handling
Template Configuration Mode Commands chapter.
authorization service.
The failure handling template defines the action to be taken when the Diameter application encounters a
failure supposing a result-code failure, tx-expiry or response-timeout. The application will take the action
given by the template. For more information on failure handling template, refer to the Failure Handling
Template Configuration Mode Commands chapter.
Important:
Only one failure handling template can be associated with the IMS authorization service. The failure
handling template should be configured prior to issuing this command.
If the association is not made to the template then failure handling behavior configured in the application with
the
the
failure-handling
command will take effect.
To support fallback to local policy in case of failure at PCRF for CCFH continue, the local policy service
should be associated with an IMS authorization service. In case of any failures, the local policy template
associated with the ims-auth service will be chosen for fallback.
should be associated with an IMS authorization service. In case of any failures, the local policy template
associated with the ims-auth service will be chosen for fallback.
Example
The following command associates a pre-configured failure handling template called
fht1
to the IMS
authorization service:
associate failure-handling-template fht1