Cisco Cisco Packet Data Gateway (PDG)
SLs Service Configuration Mode Commands
esmlc ▀
Command Line Interface Reference, StarOS Release 17 ▄
8637
Usage
Use this command to configure an E-SMLC within this SLs service. The E-SMLC provides location
information to the MME.
Up to 8 E-SMLC entries can be configured per SLs service.
The SLs service is started when the first E-SMLC is configured. The SLs service is stopped when the last E-
SMLC is removed.
A single E-SMLC can be configured to serve multiple MMEs or multiple SLs services within the same
MME.
information to the MME.
Up to 8 E-SMLC entries can be configured per SLs service.
The SLs service is started when the first E-SMLC is configured. The SLs service is stopped when the last E-
SMLC is removed.
A single E-SMLC can be configured to serve multiple MMEs or multiple SLs services within the same
MME.
Example
The following command creates an E-SMLC entry for this SLs service for an E-SMLC with an IPv6 address,
a port value of 9082 (default), and a round robin selection weight value of 5 (highest capacity).
a port value of 9082 (default), and a round robin selection weight value of 5 (highest capacity).
esmlc esmlc-id 1 ipv6-address fe80::2e0:b6ff:fe01:3b7a port 9082 weight
5.
5.