Cisco Cisco Packet Data Gateway (PDG)
PCC-Condition-Group Configuration Mode Commands
▀ pcef-address
▄ Command Line Interface Reference, StarOS Release 16
7476
range_end_ip
Specifies the ending IP address which is used for defining the range of PCEF IP addresses which is used by
subscriber in IP-CAN session.
subscriber in IP-CAN session.
range_end_ip
is an IP address and must be greater than
end_start_ip
address.
pcef_ip
/
mask
Specifies the IP address of the PCEF which is used by subscriber in IP-CAN session along with IP mask as
well.
well.
pcef_ip
must be an IP address in IPv4 or IPv6 notation.
mask
Specifies the IP address mask bits to determine the number of IP addresses of PCEF in condition.
mask
must be specified using the standard IPv4 dotted decimal notation.
profile-attributespr_attr_value
Specifies the profile attribute value in SPR to match with PCEF address in an IP-CAN session as condition.
spr_attr_value
must be an alphanumeric string of from 1 through 63 characters.
subscription-attribute
subs_prof_attr_value
Specifies the subscriber profile attribute parameter value to match with PCEF address in an IP-CAN session
as condition.
as condition.
subs_prof_attr_value
must be an alphanumeric string of from 1 through 31 characters.
Usage
Use this command to define a condition based on the PCEF IP address used by subscriber in an IP-CAN
session.
session.
Example
The following command creates a condition definition to analyze the condition based on PCEF P address
1.2.3.4
in an IP-CAN session:
pcef-address = 1.2.3.4