Cisco Cisco Packet Data Gateway (PDG)
PDSN Service Configuration Mode Commands
▀ pcf-monitor
▄ Command Line Interface Reference, StarOS Release 16
7740
num-retry
num
Default: 5
Sets the number of times that the PDSN retries to ping the PCF. When num-retry for a given PCF has been
exhausted with no response, sessions that correspond to the non-responsive PCF are terminated and
Accounting Stop records for each terminated session are generated.
Sets the number of times that the PDSN retries to ping the PCF. When num-retry for a given PCF has been
exhausted with no response, sessions that correspond to the non-responsive PCF are terminated and
Accounting Stop records for each terminated session are generated.
num
must be an integer in the range from 0 through 100.
timeout
seconds
Default: 3 seconds
The amount of time to wait for a response before retrying.
The amount of time to wait for a response before retrying.
seconds
must be in the range from 1 through 10.
Usage
Use this command to enable the PDSN service to monitor the PCFs that have sessions associated with the
PDSN service.
PDSN service.
Example
The following command enables PCF monitoring with parameters set to the defaults:
pcf-monitor
The following command enables PCF monitoring and sets the timeout to
10
seconds:
pcf-monitor timeout 10
The following command disables pcf-monitoring:
no pcf-monitor