Cisco Cisco ASR 5000
prefix and interface identifier and/or IPv4 home address acknowledgement option based on the PBU.
Step 11
The HSGW conveys the assigned IP information to the UE in a VSNCP configuration acknowledgement message.
Additionally, if an IPv6 address is assign to the UE, the HSGW sends a router advertisement message to the UE including
the assigned home network prefix.
Additionally, if an IPv6 address is assign to the UE, the HSGW sends a router advertisement message to the UE including
the assigned home network prefix.
Configuration
To configure the system to perform as a standalone HSGW in an eHRPD network environment, review the
following graphic and subsequent steps.
following graphic and subsequent steps.
Step 1
Set system configuration parameters such as activating PSCs by applying the example configurations found in the System
Administration Guide.
Administration Guide.
Step 2
Set initial configuration parameters such as creating contexts and services by applying the example configurations found
in
in
Initial Configuration, on page 45
.
Step 3
Configure the system to perform as an HSGW and set basic parameters such as interfaces and an IP route by applying
the example configurations presented in
the example configurations presented in
HSGW and MAG Service Configuration, on page 47
.
Step 4
Create a AAA context and configure parameters for AAA and policy by applying the example configuration in
and Policy Configuration, on page 49
.
Step 5
Verify and save the configuration by following the instruction in
Verifying and Saving the Configuration, on page 51
.
HSGW Administration Guide, StarOS Release 19
44
HSGW Configuration
Configuration