Cisco Cisco ASR 5000
MURAL Software Standard Installation Guide
Generating and Pushing the Information Bases
To configure your system for the data specific for your environment, you must
update the information bases (IBs) and fetch them. In some cases, you might
need to also manually modify the IBs to add or reclassify entries.
Configuring IBs for EDR
The following table shows a sample data set for setting up the IBs.
Note:
Refer to the preceding table as a sample. Use the data that matches your
environment. For example, for GGSN, you may want to use GGSN, PGW, or HA.
In this case, GGSNIP is the management IP address. For SGSN, you may want to
use SGSN, SGW, HSGW, or PDSN. In this case, SSGNIP is the service IP address.
To configure the IBs for EDR:
1.
Log in to the master Collector node and execute following commands:
[admin@collector-1 ~]#
pmx
Welcome to pmx configuration environment.
pm extension>
subshell aggregation_center
pm extension (aggregation center)>
update all ibs from image
2.
Enter the GGSN IPs and GGSN names:
pm extension (aggregation center)>
edit ib ipGgsn.map add
GGSN IP: 27.23.157.1
GGSN: GGSN1
pm extension (aggregation center)>
show ib ipGgsn.map
1[27.23.157.1][GGSN1]
pm extension (aggregation center)>
3.
Enter the SGSN IPs and SGSN name:
43
Copyright © 2016, Cisco Systems, Inc.