Cisco Cisco ASR 5000
SGSN Service Configuration Procedures
▀ Configuring the S6d Diameter Interface (S4 Only)
▄ SGSN Administration Guide, StarOS Release 18
Example Configuration
config
port ethernet <slot number/port number>
no shutdown
bind interface <s6d_interface_name> <context_name>
end
config
context <context_name>
interface <s6d_interface_name>
ip address <s6d_interface_ip_address> <subnet_mask>
exit
diameter endpoint <endpoint_name>
origin host <host_name> address <s6d_interface_ip_address>
origin realm <realm_name>
peer <peer_name> realm <realm_name> address <hss_ip_address>
route-entry peer <route_entry_name>
use-proxy
no watchdog-timeout
end
Configuring the HSS Peer Service and Interface Association for the S6d
Interface
Use the following procedure to configure the HSS Peer Service and interface association for the S6d interface:
Step 1
Configure a Diameter endpoint. If not already configured, refer to the
address.
Step 2
Associate the Diameter endpoint with an HSS peer service.
Step 3
Specify the Diameter dictionary to be used for the HSS Peer Service. The
standard-r9
dictionary must be used for
the S6d interface.