Cisco Cisco ASR 5000
SGSN Service Configuration Procedures
▀ Configuring the S13’ Interface (S4 Only, Optional)
▄ SGSN Administration Guide, StarOS Release 18
Example Configuration
config
port ethernet <s13’_interface_name>
no shutdown
bind interface s13’_interface_name> <sgsn_context_name>
end
config
context <context_name>
interface s13’_interface_ip> <subnet_mask>
exit
diameter endpoint <s13’_endpoint_name>
origin host <host_name> address <host_address>
origin realm <realm_address>
peer <peer_name> realm <realm_name > address <hss_ip_address>
route-entry peer <route_entry_name>
use-proxy
no watchdog-timeout
exit
hss-peer-service <hss_peer_service_name>
diameter hss-endpoint <s6d_endpoint_name> eir-endpoint <s13’_endpoint_name>
end
Configuring the HSS Peer Service and Interface Association for the S13’
Interface
Use the following procedure to configure the HSS Peer Service and Interface association:
Step 1
Configure an Ethernet interface to be used as a Diameter endpoint.
Step 2
Configure a Diameter endpoint and specify the IP address of the Ethernet interface configured in Step 1 as the Diameter
endpoint address.
endpoint address.
Step 3
Configure an HSS peer service and associate it with the Diameter endpoint configured for the S6d and S13’ interfaces.