Cisco Cisco ASR 5000
SGSN Service Configuration Procedures
▀ Configuring APS/MSP Redundancy
▄ SGSN Administration Guide, StarOS Release 18
Configuring APS/MSP Redundancy
ASP/MSP redundancy is only available for the OLC2 and CLC2 line cards. It is setup per linecard -- all ports share the
same setup.
same setup.
APS is enabled with the
redundancy
command in the Card configuration mode.
Important:
At this time the
aps
command in the Card Configuration Mode chapter is still in development and
should not be used. The parameters are all set by default and cannot be changed or disabled.
Related configuration for signal degrade and signal failure bit error rate thresholds for high path, low path, and transport
overhead - use the commands in the Port Channelized configuration mode.
overhead - use the commands in the Port Channelized configuration mode.
For command details, refer to the Card Configuration Mode Commands chapter and the Port Configuration Mode
Commands chapter in the Cisco UMTS Command Line Interface Reference.
Commands chapter in the Cisco UMTS Command Line Interface Reference.
Step 1
Configure a line card for either SONET or SDH.
Step 2
Configure APS for a SONET line card or MPS for an SDH line card.
Use the configuration example below:
Example Configuration
Use the following example (replacing specific values) to setup a CLC2 (Frame Relay) line card:
config
card 27
framing sdh e1
header-type 4-byte
initial-e1-framing standard
redundancy aps-mode
service-type frame-relay
no shutdown
end