Cisco Cisco ASR 5000

Page of 640
Direct Tunnel   
▀  Direct Tunnel Configuration 
 
▄  SGSN Administration Guide, StarOS Release 18 
   
Direct Tunnel Configuration 
The following configurations are provided in this section: 
 
  
 
  
The SGSN/S-GW direct tunnel functionality is enabled within an operator policy configuration. One aspect of an 
operator policy is to allow or disallow the setup of direct GTP-U tunnels. If no operator policies are configured, the 
system looks at the settings in the system operator policy named default
By default, direct tunnel support is 
 
disallowed on the SGSN/S-GW 
 
allowed on the GGSN/P-GW. 
Important:
   If direct tunnel is allowed in the default operator policy, then any incoming call that does not have 
an applicable operator policy configured will have direct tunnel allowed
For more information about operator policies and configuration details, refer to Operator Policy
Configuring Direct Tunnel Support on the SGSN 
The following is a high-level view of the steps, and the associated configuration examples, to configure the SGSN to 
setup a direct tunnel. 
Before beginning any of the following procedures, you must have completed (1) the basic service configuration for the 
SGSN, as described in the Cisco ASR Serving GPRS Support Node Administration Guide, and (2) the creation and 
configuration of a valid operator policy, as described in the Operator Policy chapter in this guide. 
Step 1 
Configure the SGSN to setup GTP-U direct tunnel between an RNC and an access gateway by applying the example 
configuration presented in the Enabling Setup of GTP-U Direct Tunnels section below. 
Step 2 
Configure the SGSN to allow GTP-U direct tunnels to an access gateway, for a call filtered on the basis of the APN, by 
applying the example configuration presented in the Enabling Direct Tunnel per APN section below. 
Important:
  It is only necessary to complete either step 2 or step 3 as a direct tunnel can not be setup 
on the basis of call filtering matched with both an APN profile and an IIMEI profile. 
Step 3 
Configure the SGSN to allow GTP-U direct tunnels to a GGSN, for a call filtered on the basis of the IMEI, by applying 
the example configuration presented in the Enabling Direct Tunnel per IMEI section below. 
Step 4 
Configure the SGSN to allow GTP-U direct tunnel setup from a specific RNC by applying the example configuration 
presented in the Enabling Direct Tunnel to Specific RNCs section below. 
Step 5 
(Optional) Configure the SGSN to disallow direct tunnel setup to a single GGSN that has been configured to allow it in 
the APN profile. This command allows the operator to restrict use of a GGSN for any reason, such as load balancing. 
Refer to the 
direct-tunnel-disabled-ggsn 
command in the SGTP Service Configuration Mode chapter of the 
Command Line Interface Reference