Cisco Cisco ASR 5000

Page of 640
  ISR with Circuit Switched Fallback 
How it Works  ▀   
SGSN Administration Guide, StarOS Release 18  ▄  
 
   
How it Works 
Listed below are the scenarios where ISR with CSFB is impacted by the SGSN, these scenarios are applicable to both 
2G and 3G when ISR is enabled: 
1.  The ISR is de-activated (by not sending ISR active status indication in RAU Accept message sent to UE) in the following 
cases: 
 
The SGSN will not sent the ISR activated indication at combined RAU/LAU procedure (As per 3GPP TS23.272, 
section 4.3.5 ,release 11.2) 
 
When the UE sends a combined RAU and LAU to a S4-SGSN, the SGSN checks the "Combined EPS/IMSI 
Attach Capability" bit in the "MS Network Capability" IE received. If that bit indicates CSFB and/or SMS over 
SGs is enabled for this UE, then the SGSN de-activates the ISR by not indicating the "ISR Activated" status in 
RAU Accept message sent to the UE. The SGSN in a CSFB/SMS over SGs configuration never indicates "ISR 
Activated" in combined RAU procedures for CSFB/SMS over SGs enabled UEs. 
2.  If CS Paging Indication is received from MME for an ISR activated subscriber, the SGSN pages to the subscriber 
indicating that the paging is for a CS call. When a Mobile Terminating call arrives at the MSC/VLR (via the G-MSC) for 
a UE that is camped on an E-UTRAN (ISR is active and the SGs interface is active between MSC and MME), the 
MSC/VLR sends a Page Request (SGsAP-PAGING-REQUEST) to the MME.
 
As ISR is active and the UE is in ECM_IDLE state, the MME forwards the CS paging message received from the 
MSC/VLR to the associated SGSN. The MME gets the SGSN information in the regular ISR activation process. The 
MME builds a "CS Paging Indication" message, which is a GTPv2 message, from the SGsAP-PAGING_REQUEST to 
the correct SGSN. The SGSN receives the CS Paging Indication message from the MME, and sends paging messages to 
RNS/BSSs. This information is described in detail in 3GPP TS 23.060.
 
3.  In Receive and handle "Alert MME Notification" and send "Alert MME "Acknowledge" scenarios. 
4.  When the SGSN sends an UE Activity Notification message over the S3 interface, if the MME sends an Alert MME 
Notification earlier for the same subscriber and the SGSN detects any UE activity (like Iu connection established and so 
on). 
5.  Handling the problem of Mobile Terminated voice calls getting dropped due to NULL SGs or SGs association at 
MSC/VLR, when the implicit detach timer expires at MME. In this case, the flag "EMM Combined UE Waiting" is set at 
the SGSN, this ensures waiting for a combined procedure (Combined RAU). A Combined RAU is forced if we receive a 
normal periodic RAU (non-combined) by sending an IMSI Detach request to UE. When a MME detaches the UE locally 
from E-UTRAN (due to PTAU timer expiry and no contact with UE at E-UTRAN till the implicit detach timer expiry at 
MME) it sends a Detach Notification with cause "local detach" to the SGSN. The SGSN sets the "EMM Combined UE 
Waiting" flag if UE is CSFB capable and this flag will be reset only after combined RAU is received.