Cisco Cisco ASR 5000
Operator Policy
▀ Verifying the Feature Configuration
▄ SGSN Administration Guide, StarOS Release 18
Verifying the Feature Configuration
This section explains how to display the configurations after saving them in a .cfg file as described in the System
Administration Guide .
Administration Guide .
Important:
All commands listed here are under Exec mode. Not all commands are available on all platforms.
Step 1
Verify that the operator policy has been created and that required profiles have been associated and configured properly
by entering the following command in Exec Mode:
by entering the following command in Exec Mode:
show operator-policy full name oppolicy1
The output of this command displays the entire configuration for the operator policy configuration.
[local]asr5x00# show operator-policy full name oppolicy1
Operator Policy Name = oppolicy1
Call Control Profile Name : ccprofile1
Validity : Valid
APN Remap Table Name : remap1
Validity : Valid
IMEI Range 711919739 to 711919777
IMEI Profile Name : imeiprof1
Include/Exclude : Include
Validity : Valid
APN NI homers1
APN Profile Name : apn-profile1
Validity : Valid
Notes:
If the profile name is shown as “Valid”, the profile has actually been created and associated with the policy. If
the Profile name is shown as “Invalid”, the profile has not been created/configured.
If there is a valid call control profile, a valid APN profile and/or valid IMEI profile, and a valid APN remap
table, the operator policy is valid and complete if the IMSI range has been defined and associated.