Cisco Cisco ASR 5000
Support for RAT/Frequency Selection Priority ID (RFSP-ID)
Monitoring and Troubleshooting the the Support for RFSP-ID ▀
SGSN Administration Guide, StarOS Release 18 ▄
Monitoring and Troubleshooting the the Support for RFSP-ID
Use the commands listed below to monitor and/or troubleshoot the support for RFSP ID.
Show Command(s) and/or Outputs
This section provides information regarding show commands and/or their outputs in support of the RFSP ID:
show call-control profile
The following new field is added in the show output to display the configured value for RAT frequency selection
priority when Handover to EUTRAN is restricted:
priority when Handover to EUTRAN is restricted:
Rfsp-override eutran-ho-restricted
show subscribers sgsn-only full all
The following new field is added in the show output to display the value of the RFSD Id. Used:
RFSP Id in Use
show subscribers gprs-only full all
The following new field is added in the show output to display the value of the RFSD Id. Used:
RFSP Id in Use
show iups-service name
The following new field is added in the show output to display if the Subscriber Profile ID for RAT/Frequency priority
IE is included or not in the outbound RANAP Direct transfer Extension and Common Id Extension message:
IE is included or not in the outbound RANAP Direct transfer Extension and Common Id Extension message:
RFSP ID
show sgsn-mode
The following new field is added in the show output to display if the RFSP ID is either included or excluded in BSSGP
DL-Unitdata messages to the BSC:
DL-Unitdata messages to the BSC:
DL Unitdata Tx