Cisco Cisco Nexus 1100 Cloud Services Platform Release Notes
3
Cisco Nexus Cloud Services Platform Release Notes, Release 5.2(1)SP1(7.3b)
Upgrading to the Cisco Nexus Cloud Services Platform Release 5.2(1)SP1(7.3b)
........................... .............................
Installation complete.
Save configuration and restart for changes to take effect
Step 2
Copy the running configuration to the startup configuration:
switch# copy running-config startup-config
[########################################] 100%
Copy complete, now saving to disk (please wait)...
switch#
Note
It takes up to 10 seconds to copy the running configuration to the startup configuration.
Therefore, you must wait for 10 seconds before proceeding to Step 3.
Therefore, you must wait for 10 seconds before proceeding to Step 3.
Step 3
Enter the reload module module command to reload the standby supervisor module and allow it to come
back online:
back online:
switch# reload module ?
<1-2> Please enter the module number
•
If the primary module is the active module:
switch# reload module 2
This command will reboot standby supervisor module. (y/n)? [n] y
about to reset standby sup
2014 Oct 2 09:15:23 switch %PLATFORM-2-PFM_MODULE_RESET: Manual restart of Module 2
from Command Line Interface
2014 Oct 2 09:15:46 switch %PLATFORM-2-MOD_REMOVE: Module 2 removed (Serial number
T023D7CC381)
2014 Oct 2 09:22:50 switch %PLATFORM-2-MOD_DETECT: Module 2 detected (Serial number
:unavailable) Module-Type Cisco Virtual Services Appliance Model :unavailable
•
If the secondary module is the active module:
switch# reload module 1
This command will reboot standby supervisor module. (y/n)? [n] y
about to reset standby sup
switch# 2014 Oct 2 09:15:23 switch %PLATFORM-2-PFM_MODULE_RESET: Manual restart of
Module 1 from Command Line Interface
2014 Oct 2 09:15:46 switch %PLATFORM-2-MOD_REMOVE: Module 1 removed (Serial number
T023D7CC382)
Step 4
When the standby supervisor module is back online, verify the high availability (HA) synchronization
is complete with the active module:
is complete with the active module:
switch# show system redundancy status
Redundancy role
---------------
administrative: primary
operational: primary
Redundancy mode
---------------
administrative: HA
operational: HA
This supervisor (sup-1)
-----------------------
Redundancy state: Active
Supervisor state: Active
Internal state: Active with HA standby
Other supervisor (sup-2)
------------------------
Redundancy state: Standby