Cisco Cisco Packet Data Gateway (PDG) Leaflet
Exec Mode show Commands (A-C)
▀ show asngw-service statistics
▄ Cisco ASR 5x00 Command Line Interface Reference
4162
peer-address ipv4_address
Specifies the IP address of an IP Peer in IPv4 dotted-decimal notation.
peer-id
<
id
>
Display the statistics based on the 6-byte BSID or ASNGW ID in addition to the IPv4 address.
verbose
Specifies that the output should display all available information. If this option is not specified then the output
will be the standard level which is the concise mode.
will be the standard level which is the concise mode.
| { grep grep_options | more }
Pipes (sends) the output of this command to the specified command. You must specify a command to which
the output of this command will be sent.
For details on the usage of
the output of this command will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter.
Usage
Use this command to display ASN-GW statistics.
Example
The following command displays information about selected MS-State-Change function.
show asngw-service statistics function-type ms-state-change
Important:
Output descriptions for commands are available in the Statistics and Counters Reference.