Cisco Cisco Packet Data Gateway (PDG) Leaflet
TACACS+ Configuration Mode Commands
▀ server
▄ Cisco ASR 5x00 Command Line Interface Reference
8388
retries
number
Release 12 and later systems only: Specifies the number of retry attempts at establishing a connection to the TACACS+
server if the initial attempt fails.
server if the initial attempt fails.
retries
number
can be an integer from 0 through 100. The default is 3. Specifying 0
(zero) retries results in StarOS trying only once to establish a connection. No further retries will be attempted.
nas-source-address
ip_address
Release 12 and later systems only: Sets the IPv4 address to be specified in the Source Address of the IP
header in the TACACS+ protocol packet sent from the NAS to the TACACS+ server.
header in the TACACS+ protocol packet sent from the NAS to the TACACS+ server.
ip_address
is
entered using IPv4 dotted-decimal notation and must be valid for the interface.
Usage
Use this command to specify TACACS+ service parameters for a specified TACACS+ server.
Example
The following command configures a priority 2, TACACS+ authetication server at IP address 192.156.1.1:
server priority 2 ip-address 192.156.1.1 authentication