Cisco Cisco ASR 5000 Administrator's Guide

Page of 62
 HeNB-GW Service Configuration Procedures   
▀  HeNB-GW Service Configuration 
 
 
▄  Cisco ASR 5x00 Home eNodeB Gateway Administration Guide 
38 
   
Step 12  Specify the SCTP port for the S1-MME interface bound in Step 11. 
Step 13  Configure the MME Group Identifier for the HeNB-GW Access service. As part of this configuration, group ID as well 
as the MME code has to be configured. MME ID is used as part of S1 setup procedure during HeNB association. It is an 
integer value ranging from 0 to 255. 
Step 14  Associate the HeNB-GW Network service configured in the step 4 to this HeNB-GW Access Service. 
Step 15  Configure the Public Land Mobile Network Identifiers MMC and MNC for this HeNB-GW Access Service. 
Step 16  Enable the S1-U Relay for this HeNB-GW Access service. Using this step, the user enters in the S1-U Relay 
Configuration Mode. This is an optional step. 
Step 17  Associate the Access and Network GTP-U services created in the Step 3 to this HeNB-GW Access service. Association 
of the GTP-U services is mandatory in case S1-U Relay is enabled. 
HeNB-GW Service Configuration 
Use the following example to configure the HeNB-GW service on system in source context to provide access to HeNBs 
towards core networks: 
configure 
------------------ Context Configuration --------------------
 
  context <ingress_ctxt_name
----------- Interface and IP addresses Configuration -----------
 
    interface <interface_name
      ip address <ipv4_addr> 255.255.255.0 
      ip address <ipv4_addr> 255.255.255.0 secondary 
      exit 
-------- Access and Network GTP-U Services Configuration ------
 
  gtpu-service <gtpu_svc_access> -noconfirm 
    bind ipv4-address <secondary1_ipv4_addr
    exit 
  gtpu-service <gtpu_svc_network> -noconfirm 
     bind ipv4-address <secondary2_ipv4_addr
    exit 
------------- HeNB-GW Network Service Configuration -----------
 
   henbgw-network-service <henb_network_svc_name> -noconfirm