Cisco Cisco Aironet 1250 Series Access Point Installation Guide
12
78-17692-02
The following procedure may vary depending on the surface on which you
mount the power injector. Also, it may be helpful to refer to the figure on page
8.
mount the power injector. Also, it may be helpful to refer to the figure on page
8.
To mount the power injector on a horizontal or vertical surface, follow these
steps:
steps:
Step 1
Use the power injector to mark the positions of the mounting tab
holes on the surface where you want to mount the power injector.
holes on the surface where you want to mount the power injector.
Step 2
To mount the power injector using a conical wall anchor and screw,
follow the steps below.
follow the steps below.
•
Drill a 3/16-in. (4.76-mm) hole at the locations you marked.
•
Install the wall anchor in the hole.
•
Insert a #5 fastener into the mounting tab holes. Tighten the
screw just enough to keep it secure in the wall anchor.
screw just enough to keep it secure in the wall anchor.