Cisco Cisco Elastic Services Controller 1.1 Developer's Guide
On Failure:
Event notification
An escEvent of type CREATE_TENANT with a status of FAILURE will be sent to Netconf subscribers if the
configuration action cannot be complete for some reason. If a FAILURE event occurs, there may be
cleanup required as described below under Handling Activation Failures
configuration action cannot be complete for some reason. If a FAILURE event occurs, there may be
cleanup required as described below under Handling Activation Failures
Operational data
After a tenant creation configuration has failed activation, there will be no change to the operational
data.
data.
Handling Activation Failures
If a failure occurs while activating a Create Tenant configuration change, the Netconf client should
explicitly bring the configuration back to a consistent state by sending the corresponding Delete Tenant
configuration change. A Delete Tenant sent at this stage should return an <ok> status, but will not
generate a Notification. The configuration change can then be retried explicitly by the Netconf client
once the underlying issue is resolved.
explicitly bring the configuration back to a consistent state by sending the corresponding Delete Tenant
configuration change. A Delete Tenant sent at this stage should return an <ok> status, but will not
generate a Notification. The configuration change can then be retried explicitly by the Netconf client
once the underlying issue is resolved.