Cisco Cisco Elastic Services Controller 1.1 Developer's Guide
On Failure:
Event notification
An escEvent of type CREATE_NETWORK with a status of FAILURE will be sent to Netconf subscribers if
the configuration action cannot be complete for some reason. If a FAILURE event occurs, there may be
cleanup required as described below under Handling Activation Failures.
the configuration action cannot be complete for some reason. If a FAILURE event occurs, there may be
cleanup required as described below under Handling Activation Failures.
Handling Activation Failures
If a failure occurs while activating a Create Network configuration change, the Netconf client should
explicitly bring the configuration back to a consistent state by sending the corresponding Delete
Network configuration change. The configuration change can then be retried explicitly by the Netconf
client once the underlying issue is resolved.
explicitly bring the configuration back to a consistent state by sending the corresponding Delete
Network configuration change. The configuration change can then be retried explicitly by the Netconf
client once the underlying issue is resolved.