Cisco Cisco Elastic Services Controller 2.3 Developer's Guide
6.1.3 Create Tenant
6.1.3.1 Netconf Request
<rpc message-id="1" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<source>
<running/>
</source>
<config>
<edit-config>
<source>
<running/>
</source>
<config>
<esc_datamodel xmlns="http://www.cisco.com/esc/esc">
<tenants>
<tenant>
<name>mytenant</name>
</tenant>
</tenants>
</esc_datamodel>
</config>
</edit-config>
<tenants>
<tenant>
<name>mytenant</name>
</tenant>
</tenants>
</esc_datamodel>
</config>
</edit-config>
</rpc>
Note – Tenant Operations(Create and Delete) are not supported for VMware VIM !
6.1.3.2 Netconf Response
An rpc-reply response is returned with a status of ok if the request was accepted for activation, or a
status of rpc-error if the request was rejected. See section
status of rpc-error if the request was rejected. See section
6.1.3.3 Configuration Activation
On Success:
Event notification
An escEvent of type CREATE_TENANT with a status of SUCCESS will be sent to Netconf subscribers once
the configuration activation has completed. This indicates that the activation workflow is complete and
the configuration resource has been successfully created in the VIM.
the configuration activation has completed. This indicates that the activation workflow is complete and
the configuration resource has been successfully created in the VIM.
<notification xmlns="urn:ietf:params:xml:ns:netconf:notification:1.0">
<eventTime>2015-05-05T19:38:27.71+00:00</eventTime>
<eventTime>2015-05-05T19:38:27.71+00:00</eventTime>
<escEvent xmlns="http://www.cisco.com/esc/esc">
<status>SUCCESS</status>
<status_message>Tenant successfully created</status_message>
<tenant>mytenant</tenant>
<status>SUCCESS</status>
<status_message>Tenant successfully created</status_message>
<tenant>mytenant</tenant>
<vm_source/>
<vm_target/>
<event>
<type>CREATE_TENANT</type>
</event>
</escEvent>
</notification>
<vm_target/>
<event>
<type>CREATE_TENANT</type>
</event>
</escEvent>
</notification>