Cisco Cisco Prime Network Registrar 8.0 Troubleshooting Guide
Disaster Recovery Guide for Cisco Prime Network Registrar IPAM 8.0 - Using MySQL Replication 13
in the $INCHOME/etc/support directory of the Cisco Prime
Network Registrar IPAM installation:
> $INCHOME/etc/support/PromoteExec.sh
Network Registrar IPAM installation:
> $INCHOME/etc/support/PromoteExec.sh
3.1.2.4 Restart the DR Executive Cisco Prime Network Registrar IPAM
services
3.1.2.4.1 Linux/Solaris
Run the Cisco Prime Network Registrar IPAM script to restart
all services on the DR Executive:
> $INCHOME/etc/incontrol restart
Choose Stop Cisco Prime Network Registrar IPAM, wait
for the services to stop, then choose Start Cisco Prime
all services on the DR Executive:
> $INCHOME/etc/incontrol restart
Choose Stop Cisco Prime Network Registrar IPAM, wait
for the services to stop, then choose Start Cisco Prime
Network Registrar IPAM.
3.1.3 Return to Normal
This section describes the procedure necessary to return to
normal operation where the Production Executive is in use,
and the DR Executive is in standby mode.
normal operation where the Production Executive is in use,
and the DR Executive is in standby mode.
3.1.3.1 Change the IP of the DR Executive
Follow the same procedure described above to change
the IP of the DR Executive back to its original IP.
the IP of the DR Executive back to its original IP.
3.1.3.2 Prepare the Active Master on the DR Executive for demotion
The Active Master database running on the DR Executive
must be demoted so that it no longer accepts any
changes. But this demotion cannot take place until the
database on the Production Executive is back in synch
database on the Production Executive is back in synch
with the Active Master on the DR Executive. This
requires that we dump the current state of the database
requires that we dump the current state of the database
on the DR Executive in order to load the data on the
restored Production Executive. To accomplish this,
restored Production Executive. To accomplish this,
the prepmaster.sh script provided in the
$INCHOME/etc/support directory must be run with
$INCHOME/etc/support directory must be run with
the „-d‟ command line option. This will cause the
database to be dumped and the appropriate options for
database to be dumped and the appropriate options for
the prepslave.sh script will be generated.