Cisco Cisco Prime Network Registrar Jumpstart 8.3 Installation Guide
2
Cisco Prime Network Registrar Jumpstart 8.3 Quick Start Guide
Introduction
You can connect to each layer as described below:
Connecting to Virtual Appliance (Open Virtual Appliance) Layer—You can connect to the Cisco Prime Network
Registrar application layer using a web browser. Use http://vaip:8080 for local and http://vaip:8090, where vaip is
the virtual appliance IP address (which is also the IP address of the Linux Operating System). For a secure connection
to the Cisco Prime Network Registrar Web UI, use https://vaip:8443.
Registrar application layer using a web browser. Use http://vaip:8080 for local and http://vaip:8090, where vaip is
the virtual appliance IP address (which is also the IP address of the Linux Operating System). For a secure connection
to the Cisco Prime Network Registrar Web UI, use https://vaip:8443.
To access the Cisco Prime Network Registrar Command Line Interface (CLI), you can use an SSH connection to the
virtual appliance IP address using ssh -l root vaip.
virtual appliance IP address using ssh -l root vaip.
You can manage the Linux OS by connecting to it using ssh -l root vaip. There is no Windows system installed on
the Cisco Prime Network Registrar virtual appliance, but the standard Linux commands necessary to manage a
networking application are all present on the Linux OS.
the Cisco Prime Network Registrar virtual appliance, but the standard Linux commands necessary to manage a
networking application are all present on the Linux OS.
Connecting to ESXi Hypervisor Layer—Connect to the ESXi hypervisor layer, identified by the IP address esxip, using
the VMware vSphere client. esxip is the IP address designated to the ESXi layer.
the VMware vSphere client. esxip is the IP address designated to the ESXi layer.
Note:
The VMware vSphere client is supported only on systems running Microsoft Windows.
Connecting to Cisco Integrated Management Controller (CIMC) UCS Management Console—This allows you to
configure and manage the ESXi layer. You can connect to the CIMC by using a browser using https://ucsip/. ucsip is
the IP address assigned to the Jumpstart. After you log into CIMC, you can start the KVM console to get access to
the ESXi configuration screen and manage hardware (power, temperature, fan RPM).
configure and manage the ESXi layer. You can connect to the CIMC by using a browser using https://ucsip/. ucsip is
the IP address assigned to the Jumpstart. After you log into CIMC, you can start the KVM console to get access to
the ESXi configuration screen and manage hardware (power, temperature, fan RPM).