Cisco Cisco Prime Access Registrar Jumpstart 7.0 Installation Guide

Press F2 to customize the system.

The virtual KVM console needs to capture the mouse to accept input. It may be necessary on some systems to use 
the mouse to select the Single Cursor option from the Tools menu of the KVM Console window. If nothing happens 
when you press F2, select the Session Options from the Tools menu and click OK. Usually this causes the mouse to 
be captured, and then the functions keys will make it through to the console. If you want the mouse back, you can 
press F12.

Press F2 again to view the login window.

Log into the host. The default username is root, and there is no password.

Select Configure Password option and reconfigure the root password after you log in.

Use the arrow keys to select Configure Management Network and press Enter.

Once you log in, you should reconfigure the root password.

For IP configuration:

Use the arrow keys to select IP Configuration and press Enter.

Use the arrow keys to select Set Static IP address and Network Configuration and use the status bar to enable the option.

Use the arrow keys to select IP Address and enter the IP address.

Use the arrow keys to select Subnet Mask and enter the subnet mask.

Use the arrow keys to select Default Gateway and enter the gateway address.

Press Enter to accept the IP Configuration updates.

If you want to use IPv6 with Prime Access Registrar, use the arrow keys to select the IPv6 Configuration and enter 
the requested information.

To configure the DNS servers:

Use the arrow keys to select DNS Configuration and press Enter.

Use the arrow keys to select Primary DNS Server and enter the IP address of the primary DNS server.

Use the arrow keys to select Alternate DNS Server and enter the IP address of the alternate DNS server.

Use the arrow keys to select Hostname and enter the hostname.

Ensure that you enter the entire hostname, including the domain name. For example, localhost.localdomain.

Press Enter to accept the DNS Configuration updates.

If you have a VLAN configured on the switch to which the ESXi is connected, use the arrow keys to select the VLAN 
(optional) and press Enter.

Enter the VLAN for this network connection and press Enter to accept the change. 

Press Esc to exit the Configure Management Network window which you are in now.

Use the arrow keys to select Test Management Network and press Enter.

You can see the addresses to be pinged and the hostname to be resolved. Use the arrow keys and select the address to 
be pinged and press Enter. The test pings your default gateway and DNS servers and tests the connectivity. Press Enter 
when the test is complete.