Cisco Cisco Broadband Access Center for Cable 4.0 Release Notes
19
Release Notes for Cisco Broadband Access Center 4.0.1
OL-16643-01
Documentation Errata
Documentation Errata
The following errata exist in the documentation for BAC 4.0:
•
Cisco Broadband Access Center DPE CLI Reference—Chapter 3, “DPE Configuration Commands”
(see
(see
–
For the interface ip provisioning command on page 3-13, in the “Syntax Description,” the first
numbered item on deleting an existing IP address should have the command syntax no interface
ip ip_address provisioning, with the IP address included. (CSCsq61680)
numbered item on deleting an existing IP address should have the command syntax no interface
ip ip_address provisioning, with the IP address included. (CSCsq61680)
–
For the service tftp ipv4 | ipv6 blocksize command on page 3-17, in the “Defaults” section of
Table 3-2, the default upper and lower limits for IPv4 block sizes should be 512 and 1428 bytes,
respectively. The IPv6 block sizes should both be 1448 bytes. (CSCsm67127)
Table 3-2, the default upper and lower limits for IPv4 block sizes should be 512 and 1428 bytes,
respectively. The IPv6 block sizes should both be 1448 bytes. (CSCsm67127)
–
For the service tftp ipv4 | ipv6 enabled command on page 3-18, the well-known TFTP port is
69, not 60 as indicated. (CSCsq61680)
69, not 60 as indicated. (CSCsq61680)
•
Installation and Setup Guide for the Cisco Broadband Access Center—Chapter 5, “Upgrading
Network Registrar Extensions” (see
Network Registrar Extensions” (see
):
–
On page 5-4, in “Upgrading Network Registrar Extensions,” the 4.0 extension points must be
properly activated following an upgrade. To do this, the following step has been added to the
procedure:
properly activated following an upgrade. To do this, the following step has been added to the
procedure:
Step 6 Enable the Network Registrar extensions by running the following nrcmd command
from the Network Registrar home directory (being sure to include the redirect to the file).
from the Network Registrar home directory (being sure to include the redirect to the file).
For example:
# /opt/nwreg2/local/usrbin/nrcmd -s -b
< /opt/CSCObac/cnr_ep/bin/bpr_cnr_enable_extpts.nrcmd
(CSCso78513)
Related Documentation
These related guides support this BAC release:
•
Installation and Setup Guide for Cisco Broadband Access Center 4.0
(
(
)
•
Cisco Broadband Access Center DPE CLI Reference 4.0
(
(
)
•
Administrator Guide for Cisco Broadband Access Center 4.0
(
(
)
Additionally, you can refer to:
•
Release Notes for Cisco Network Registrar 7.0
(
(
)