Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
DLP-G317 Change Node Access and PM Clearing Privilege
This task provisions the physical access points and shell
programs used to connect to the ONS 15454 and sets the user
security level that can clear node performance monitoring (PM)
data.
programs used to connect to the ONS 15454 and sets the user
security level that can clear node performance monitoring (PM)
data.
Purpose
None
Tools/Equipment
"DLP-G46 Log into CTC" task in the "
" document.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Superuser only
Security Level
Procedure
Step 1
In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > Security > Access tabs.
Step 2
In the Access area, provision the following:
• LAN access—Choose one of the following options to set the access paths to the node:
◦No LAN Access—Allows access to the node only through DCC connections. Access through the
TCC2/TCC2P/TCC3/TNC/TNCE/TSC/TSCE RJ-45 port and backplane is not permitted.
◦Front only—Allows access through the TCC2/TCC2P/TCC3/TNC/TNCE/TSC/TSCE RJ-45 port. Access
through the DCC and the backplane is not permitted.
◦Backplane only—Allows access through DCC connections and the backplane. Access through the
TCC2/TCC2P/TCC3/TNC/TNCE/TSC/TSCE RJ-45 port is not allowed.
◦Front and Backplane—Allows access through DCC, TCC2/TCC2P/TCC3/TNC/TNCE/TSC/TSCE RJ-45
port, and backplane connections.
• Restore Timeout—Sets a time delay for enabling of front and backplane access when DCC connections are lost and
"DCC only" is chosen in LAN Access. Front and backplane access is enabled after the restore timeout period has
passed. Front and backplane access is disabled as soon as DCC connections are restored.
passed. Front and backplane access is disabled as soon as DCC connections are restored.
• Disable IPv4 access for IPv6 enabled ports—Select this option to disable IPv4 on ports which are IPv6 enabled.
Before you select this option, ensure that IPv6 is enabled and the node is not in multishelf mode.
Step 3
In the Shell Access area, set the shell program used to access the node:
• Access State—Allows you to set the shell program access mode to Disable (disables shell access), Non-Secure, or
Secure. Secure mode allows access to the node using the Secure Shell (SSH) program. SSH is a terminal-remote host
Internet protocol that uses encrypted links.
Internet protocol that uses encrypted links.
79