Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
Step 4
If needed, modify the UDP port in the UDP Port field. The default UDP port for SNMP is 162.
Step 5
Set the Trap Version field for either SNMPv1 or SNMPv2.
Refer to your NMS documentation to determine whether to use SNMPv1 or SNMPv2.
Refer to your NMS documentation to determine whether to use SNMPv1 or SNMPv2.
Step 6
If you want the SNMP agent to accept SNMP SET requests on certain MIBs, check the Allow SNMP Sets check box. If
this box is not checked, SET requests are rejected.
this box is not checked, SET requests are rejected.
Step 7
If you want to set up the SNMP proxy feature to allow network management, message reporting, and performance statistics
retrieval across ONS firewalls, check the Enable SNMP Proxy check box located on the SNMP tab.
retrieval across ONS firewalls, check the Enable SNMP Proxy check box located on the SNMP tab.
Step 8
Click Apply.
Step 9
SNMP settings are now modified. To view SNMP information for each node, highlight the node IP address in the Trap
Destinations area of the Trap Destinations area. Confirm that the changes appear; if not, repeat the task.
Destinations area of the Trap Destinations area. Confirm that the changes appear; if not, repeat the task.
Step 10
Return to your originating procedure (NTP).
DLP-G198 Delete SNMP Trap Destinations
This task deletes SNMP trap destinations on an ONS 15454
node.
node.
Purpose
None
Tools/Equipment
"DLP-G46 Log into CTC" task in the "
" document.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Provisioning or higher
Security Level
Procedure
Step 1
In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > SNMP tabs.
Step 2
In the Trap Destinations area, click the trap that you want to delete.
Step 3
Click Delete. A confirmation dialog box appears.
Step 4
Click Yes. Confirm that the changes appear; if not, repeat the task.
Step 5
Return to your originating procedure (NTP).
94