Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
Onsite or remote
Onsite/Remote
Provisioning or higher
Security Level
This procedure will affect the service of unprotected circuits that pass through the ROADM node.
Caution
This procedure applies to two ROADM nodes, where ROADM Node 1 has amplifier cards (such as,
OPT-BST and OPT-PRE) or optical service channel cards (OSCM or OSC-CSM) installed on both the
sides of the shelf and 40-WSS-C/40-DMX-C card (or the 32WSS/32DMX and 32WSS-L/32DMX-L
cards) installed in Side A (Slots 1 through 6) and the ROADM Node 2 has amplifier cards (such as,
OPT-BST and OPT-PRE) or optical service channel cards (OSCM or OSC-CSM) installed on both the
sides of the shelf and 40-WSS-C/40-DMX-C card (or the 32WSS/32DMX and 32WSS-L/32DMX-L
cards) installed in Side B (Slots 12 through 17).
OPT-BST and OPT-PRE) or optical service channel cards (OSCM or OSC-CSM) installed on both the
sides of the shelf and 40-WSS-C/40-DMX-C card (or the 32WSS/32DMX and 32WSS-L/32DMX-L
cards) installed in Side A (Slots 1 through 6) and the ROADM Node 2 has amplifier cards (such as,
OPT-BST and OPT-PRE) or optical service channel cards (OSCM or OSC-CSM) installed on both the
sides of the shelf and 40-WSS-C/40-DMX-C card (or the 32WSS/32DMX and 32WSS-L/32DMX-L
cards) installed in Side B (Slots 12 through 17).
Caution
In this procedure, ROADM Node 1 will be used as node controller and ROADM Node 2 will be added
to the multishelf configuration as a subtending shelf.
to the multishelf configuration as a subtending shelf.
Note
Procedure
Step 1
Complete the “NTP-G139 Verify Cisco Transport Planner Reports and Files” task in the chapter “Turn Up a Node” of the
Cisco ONS 15454 DWDM Network Configuration Guide to verify that you have the files and reports prepared by Cisco
Transport Planner for the ROADM nodes.
Cisco ONS 15454 DWDM Network Configuration Guide to verify that you have the files and reports prepared by Cisco
Transport Planner for the ROADM nodes.
27