Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
"NTP-G30 Install the DWDM Cards” task in the chapter “Turn
Up a Node” of the Cisco ONS 15454 DWDM Network
Configuration Guide.
Up a Node” of the Cisco ONS 15454 DWDM Network
Configuration Guide.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Provisioning or higher
Security Level
Procedure
Step 1
Complete the "DLP-G46 Log into CTC" task in the
document at the node where
you want to change the TDC-CC or TDC-FC card settings. If you are already logged in, continue with the next step.
Step 2
Complete the “NTP-G103 Back Up the Database” task in the chapter “Maintain the Node” of the Cisco ONS 15454 DWDM
Network Configuration Guide.
Network Configuration Guide.
Changing the CD value of the T-DCU can severely affect the performance of the channels travelling through the
T-DCU. As a general rule the new value is provided through an additional analysis performed by the CTP. In this
case, complete the “NTP-G328 Add, Modify, and Delete ANS Parameters” task in the chapter “Turn Up a Node”
of the Cisco ONS 15454 DWDM Network Configuration Guide. If for some reason, the “NTP-G328 Add, Modify,
and Delete ANS Parameters” task cannot be applied, then a skilled operator can directly change the CD value
according to the CTP findings. To modify the CD setting of the TDC-CC or TDC-FC card proceed to the next
step.
T-DCU. As a general rule the new value is provided through an additional analysis performed by the CTP. In this
case, complete the “NTP-G328 Add, Modify, and Delete ANS Parameters” task in the chapter “Turn Up a Node”
of the Cisco ONS 15454 DWDM Network Configuration Guide. If for some reason, the “NTP-G328 Add, Modify,
and Delete ANS Parameters” task cannot be applied, then a skilled operator can directly change the CD value
according to the CTP findings. To modify the CD setting of the TDC-CC or TDC-FC card proceed to the next
step.
Note
Step 3
To modify the CD setting of the TDC-CC or TDC-FC card, perform any of the following tasks as needed:
As the operation is traffic affecting, change the CD value during a maintenance window.
Note
•
•
Step 4
Complete the “NTP-G103 Back Up the Database” task in the chapter “Maintain the Node” of the Cisco ONS 15454 DWDM
Network Configuration Guide.
Stop. You have completed this procedure.
Network Configuration Guide.
Stop. You have completed this procedure.
DLP-G526 Modify the CD Value of the TDC-CC and TDC-FC When Connected to OPT-AMP-C, OPT-PRE,
40-SMR-1 and 40-SMR-2 Cards
40-SMR-1 and 40-SMR-2 Cards
This procedure allows you to modify the CD value when the
TDC-CC and TDC-FC cards are connected to the DC ports of
the OPT-PRE, OPT-AMP-C, 40-SMR-1 and 40-SMR-2 cards.
TDC-CC and TDC-FC cards are connected to the DC ports of
the OPT-PRE, OPT-AMP-C, 40-SMR-1 and 40-SMR-2 cards.
Purpose
35