Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
Onsite or remote
Onsite/Remote
Superuser only
Security Level
Procedure
Step 1
In node view (single-shelf mode), or shelf view (multishelf mode), double-click the card where you want to view PM
thresholds. The card view appears.
thresholds. The card view appears.
Step 2
Click the Provisioning tab.
Step 3
Click the Thresholds subtabs. The subtab names vary depending on the card selected.
Step 4
Click Reset to Default.
Pressing the Reset button can mask problems if used incorrectly. This button is commonly used for testing
purposes.
purposes.
Caution
Step 5
Click Yes in the Reset to Default dialog box.
Step 6
Verify that the PM thresholds have been reset.
Step 7
Return to your originating procedure (NTP).
DLP-G137 Set the Auto-Refresh Interval for Displayed PM Counts
This task changes the window auto-refresh intervals for
updating the PM counts.
updating the PM counts.
Purpose
None
Tools/Equipment
"DLP-G46 Log into CTC" task at
document.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Retrieve or higher
Security Level
Procedure
Step 1
In node view (single-shelf mode), or shelf view (multishelf mode), double-click the card where you want to set the
auto-refresh interval for displayed PM counts. The card view appears.
auto-refresh interval for displayed PM counts. The card view appears.
Step 2
Click the Performance tab.
Step 3
If you want to set the PM auto-refresh interval for a subtab, click the relevant subtab(s), located along the left side of the
Performance tab.
Performance tab.
59