Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
•
To refresh, reset, or clear PM counts, see the "
NTP-G73 Change the PM Display, on page 51
" procedure.
Note
Stop. You have completed this procedure.
DLP-G607 View Optics PM Parameters for the TNC, TNCE, and TNCS Cards
This task enables you to view the optics PM counts on TNC
,TNCE, and TNCS cards to detect possible performance
problems. This task is applicable on the ONS 15454 M2, ONS
15454 M6, and NCs 2015 shelves.
,TNCE, and TNCS cards to detect possible performance
problems. This task is applicable on the ONS 15454 M2, ONS
15454 M6, and NCs 2015 shelves.
Purpose
None
Tools/Equipment
"DLP-G46 Log into CTC" task at
document.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Retrieve or higher
Security Level
The optics PMs for data parameters can be viewed only after creating a pluggable port module (PPM).
See the "NTP-G128 Manage Pluggable Port Modules" procedure in the chapter, "Provision Transponder
and Muxponder Cards" of the Cisco ONS 15454 DWDM Line Card Configuration Guide for more
information about PPMs.
See the "NTP-G128 Manage Pluggable Port Modules" procedure in the chapter, "Provision Transponder
and Muxponder Cards" of the Cisco ONS 15454 DWDM Line Card Configuration Guide for more
information about PPMs.
Note
Procedure
Step 1
In node view (single-shelf mode), or shelf view (multishelf mode), double-click the TNC ,TNCE, or TNCS card where
you want to view PM counts. The card view appears.
you want to view PM counts. The card view appears.
Step 2
Click the Performance > Optics PM tabs.
Step 3
View the PM parameter names that appear in the Param column of the Current Values and Historical PM tabs. In the
Historical PM tab, the PM parameter values appear in the Curr (current) and Prev-n (previous) columns.
Historical PM tab, the PM parameter values appear in the Curr (current) and Prev-n (previous) columns.
Step 4
Return to your originating procedure (NTP).
62