Cisco Cisco Broadband Access Center Telco Wireless 3.8

This command closes a Telnet or console connection to the DPE and returns to the login prompt on the 
console.

This is an example of how to use the exit command:

dpe# exit

Connection closed.

This command displays a help screen to assist you in using the DPE CLI. If you need help on a particular 
command, or to list all available commands, enter either ? or system commands, respectively.

Two types of help are provided:

Full help is available when you are ready to enter a command argument, such as show ?, and 
describes each possible argument.

Partial help is provided when you enter an abbreviated argument and want to know what arguments 
match the input. For example, show stat?.

This is an example of how to use the help command:

dpe# help

Help may be requested at any point in a command by entering a question mark '?'. If 

nothing matches, the help list will be empty and you must backup until entering a '?' 

shows the available options.

1) Full help is available when you are ready to enter a command argument (e.g. 'show ?') 

and describes each possible argument.

2) Partial help is provided when an abbreviated argument is entered and you want to know 

what arguments match the input (e.g. 'show stat?'.)

This command is used to set the DPE host name. The hostname is used primarily for display in the DPE 
and should correspond to the DNS name for the DPEs IP address. If you change the host name, you must 
run the 

 command for the changes to take effect.

When entering the hostname command, you must use this syntax:

hostname <hostname>