Cisco Cisco Broadband Access Center Telco Wireless 3.8
C-16
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
System Commands
Syntax Description
When entering the show interface ethernet <0...1> config command, you must use this syntax:
show interface ethernet <0...1> config
Where:
•
<0...1>—identifies the Ethernet interface number
Examples
This is an example of how to use the show interface ethernet <0...1> config command:
dpe# show interface ethernet 0 config
ip address = 10.10.10.5
netmask = 255.255.255.0
enabled = true
for prov = true
show interface ethernet <0...1> stats
Usage Guidelines
This command shows statistics for the DPE’s Ethernet interface.
Syntax Description
When entering the show interface ethernet <0...1> stats command, you must use this syntax:
show interface ethernet <0..1> stats
Where:
•
<0...1>—identifies the Ethernet interface number
Examples
This is an example of how to use the show interface ethernet <0...1> stats command:
show ip route
Usage Guidelines
This command shows the DPEs IP routing table, including any custom routes. the default gateway is
indicated by The G flag in the flags column indicates the default gateway start.
indicated by The G flag in the flags column indicates the default gateway start.
dpe# show interface ethernet 0 stats
eth0
Link encap:Ethernet HWaddr 00:B0:D0:F7:07:C2
inet addr:10.10.10.5 Bcast:10.10.10.2 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3539 errors:0 dropped:0 overruns:0 frame:0
TX packets:3233 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100