Cisco Cisco Broadband Access Center Telco Wireless 3.8
C-25
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
DPE Configuration Commands
traceroute (IP)
Usage Guidelines
This command identifies the route to a specified host including each hop between the DPE and the
destination host. This command is useful when verifying communication and determining if gateways
and routes are correctly configured.
destination host. This command is useful when verifying communication and determining if gateways
and routes are correctly configured.
Syntax Description
When entering the traceroute (IP) command, you must use this syntax:
traceroute <x.x.x.x>
Where:
•
<x.x.x.x>—identifies the IP address of the host
Examples
This is an example of how to use the traceroute (IP) command:
dpe# traceroute 10.10.10.5
Press <enter> to stop.
traceroute to 10.10.10.5 (10.10.10.5), 30 hops max, 38 byte packets
1 10.10.10.5 0.454 ms 0.239 ms 0.230 ms
Stopped.
DPE Configuration Commands
This section describes the configuration commands that affect DPE. These commands include:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•