Cisco Cisco Broadband Access Center Telco Wireless 3.8

This is an example of how to use the packetcable snmp key-material command:

dpe# packetcable snmp key material ciscosystems101

%OK (Requires DPE restart "> dpe reload")

This command dynamically sets the time (in seconds) that the PacketCable SNMP service will wait for 
a response to any SNMP SET operation.

When entering the packetcable snmp timeout command, you must use this syntax:

packetcable snmp timeout <time>

Where:

<time>—indicates the time the PacketCable SNMP service will wait, in seconds. The default value 
is 10 seconds.

This is an example of how to use the packetcable snmp timeout command:

dpe# packetcable snmp timeout 15

%OK

This command shows recent PacketCable registration service log entries.  This log contains information 
about the general PacketCable registration service including logging of provisioning errors or severe 
problems.

This is an example of how to use the show packetcable registration log command:

dpe# show packetcable registration log

DEBUG [MtaListener] 2002-09-16 14:57:48,878 (Sequence.java:141) - <== 

KERBEROS.TransitedEncoding.decode()

This command displays a specified number of lines from the PacketCable registration service log file.

When using this command, you must use this syntax:

show packetcable registration log last <1-9999>