Cisco Cisco Broadband Access Center for Cable 4.1

This is an example of how to use the show log command:

dpe# show log

2001 12 21 11:22:20 CDT: %BPR-5: Notification DPE: Device Provisioning Engine starting up

This command shows the specified number of recent log entries for the DPE. Check this log, when the 
system is experiencing difficulties and, if the log contains insufficient information, enable the debug 
logging function and experiment with the different categories related to the problem.

When entering the show log last command, you must use this syntax:

show syslog last <1..999>

Where:

<1..999>—identifies the number of log entries that you want displayed

This is an example of how to use the show log last command:

dpe# show log last 1

2001 12 21 11:28:17 CDT: %BPR-5: Notification DPE: Device Provisioning Engine starting up

This command displays the running DPE log, which starts showing all messages logged to the DPE log. 
The command continues to run until you press Enter. Check this log when the system is experiencing 
difficulties. If the log contains insufficient information, enable the debug logging function and 
experiment with the different categories related to the problem.

This is an example of how to use the show log run command:

dpe# show log run

Press <enter> to stop.

2001 12 21 11:43:43 CDT: %BPR-5: Notification DPE: Device Provisioning Engine starting up

2001 12 21 11:43:44 CDT: %BPR-6: Info DPE: Attempt to connect to RDU 

BPR_host.cisco.com:49187 failed;

2001 12 21 11:43:44 CDT: %BPR-6: Info TFTP: Ready to service requests

Stopped.