Cisco Cisco Transport Manager 9.2 Technical References
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
17
Cisco Transport Manager Release 9.2 ML Provisioning Methodology
OL-21044-01
Protection Support on ML-Series Cards
Figure 5
Card Selection—Create Layer 2 Topology Wizard (IEEE 802.17 RPR)
After you select the protection, commands are issued on the active and protection ML1000 cards, as
follows:
follows:
•
MAC addresses are configured on both the active and protection cards for the IEEE RPR interface:
–
Active card protection configuration
interface RPR-IEEE0
mac-address MAC address of the interface
[MAC address range is from 0000.1111.1111
to 0000.9999.9999]
–
Protection card protection configuration
interface RPR-IEEE0
mac-address MAC address of the interface
[MAC address range is from 0000.1111.1111
to 0000.9999.9999]
•
After the MAC address is configured, the following commands are present on the active and
protection cards:
protection cards:
–
Active card protection configuration
interface RPR-IEEE0
rpr-ieee ri mode primary peer MAC address of the active card
[MAC address range is
from 0000.1111.1111 to 0000.9999.9999]
–
Protection card protection configuration
interface RPR-IEEE0
rpr-ieee ri mode secondary peer MAC address of the protection card
[MAC address
range is from 0000.1111.1111 to 0000.9999.9999]