Cisco Cisco Prime Optical 9.6 Technical References

Cisco Prime Optical 9.6.3 ML Provisioning Methodology

OL-28046-01

Packet over SONET, Ethernet, and Shared Packet Ring Port Provisioning

interface POS1

service-policy output POLICY_QOS_OUT

Crc {16|32}

[Crc 16 between ML and E-series; otherwise Crc 32]

[The following commands are not issued by Prime Optical; rather, these are default ML

settings]

No ip address

No ip route-cache

Note

Cisco IOS software supports multiple match cos commands for each class-map command, but
Prime Optical supports only one for each.

Packet over SONET, Ethernet, and Shared Packet Ring Port
Provisioning

You can use the Create Layer 2 Service wizard, Modify Ports dialog box, Modify VLANs dialog box,
Add L2 Service Drops wizard, or Modify L2 Drops wizard to provision the parameters described in the
following table.

Table 2

Port Provisioning Parameter Support

Card and Port
Types

MTU Size

Speed

Duplex

Flow Control
(Send)

Flow Control
(Receive)

Enable (No
Shutdown)/Disable
(Shutdown)

ML100T
card

Ether

Supported

Not supported

Supported

PoS

Supported only
for PTP

Not supported

Supported

SPR

Supported only
for RPR

Not supported

ML1000
(Ether)
card

Ether

Supported

Supported only
for Auto

Supported
only for Auto

Supported

PoS

Supported only
for PTP

Not supported

Supported

SPR

Supported only
for RPR

Not supported

ML100FX
card

Ether

Not supported

Only 100 is
supported

Only Full is
supported

Supported

Not supported

Supported

PoS

Supported only
for PTP

Not supported

Supported

SPR

Supported only
for RPR

Not supported