Cisco Cisco Prime Network 3.10 Installation Guide
25
c.
In most cases, you should be able to use the default values for the other fields. For a full description of all the fields in
this tab, see “VNE General Settings” in the
this tab, see “VNE General Settings” in the
You can change these
settings at a later stage, if necessary, by right-clicking the VNE and selecting Properties.
Figure 7
New VNE - General Tab
Step 4
In the SNMP tab, enter SNMP credentials. For a full description of all the fields in this tab, see “VNE SNMP Settings”
in the
in the
.
Step 5
In the Telnet/SSH tab, check the Enable checkbox and enter Telnet prompt information, as follows:
a.
In the Prompt field, enter the prompt expected from the device.
b.
In the Run field, enter the response to the expected prompt.