Cisco Cisco Prime Optical 10.3 Developer's Guide
Cisco Prime Optical 10.3 GateWay/CORBA Programmer Reference Guide
400
• Short storeTime24hr—Minimum store time, in hours, for 24-hour data. Prime Optical reports
0 if PM data is held indefinitely.
• Short storeTime15min—Minimum store time, in hours, for 15-minute data. Prime Optical
reports 0 if PM data is held indefinitely.
Throws
Compliance
TMF-defined.
TMF-defined.
3.13.10 getAllCurrentPMData
Synopsis
Description
This interface enables an NMS to request a filtered set (scoped by the input parameter
pmParameters) of the current PM data for a list of TP measurement points. Within the request for
each measurement point, granularity (15 min, 24 hr, N/A) and location (nearEnd, farEnd,
bidirectional) can be specified. The operation mode is best effort.
Current data is generally marked as incomplete, as the current bin is not completed. If no PM
data is available as specified, an empty list is returned.
This interface uses an iterator to allow the NMS to handle a large number of objects.
For a list of supported layer rates and PM parameters, see
This interface enables an NMS to request a filtered set (scoped by the input parameter
pmParameters) of the current PM data for a list of TP measurement points. Within the request for
each measurement point, granularity (15 min, 24 hr, N/A) and location (nearEnd, farEnd,
bidirectional) can be specified. The operation mode is best effort.
Current data is generally marked as incomplete, as the current bin is not completed. If no PM
data is available as specified, an empty list is returned.
This interface uses an iterator to allow the NMS to handle a large number of objects.
For a list of supported layer rates and PM parameters, see
If the layer rate is L3_Optical_Channel (which requires a DWDM CTP), Prime Optical uses the
naming convention defined in the TMF for the CTP.
The CTP format description differs depending on whether it is related to the DWDM.
L3_Optical_Channel is the only layer rate that requires it. If the list of requested layer rates is
composed of one element only equal to LR_Optical_Channel, the CTP is considered a DWDM
CTP.
For CPT 200, CPT 200 SDH, CPT 600, and CPT 600 SDH, a subset of ONS 15454 SONET and
ONS 15454 SDH parameters is supported. The supported parameters match the parameters
associated to the port equipment supported by CPT.
The getAllCurrentPMData interface returns values with a 15-minute granularity if the requested
granularity is 24 hour. For a list of supported layer rates, see
naming convention defined in the TMF for the CTP.
The CTP format description differs depending on whether it is related to the DWDM.
L3_Optical_Channel is the only layer rate that requires it. If the list of requested layer rates is
composed of one element only equal to LR_Optical_Channel, the CTP is considered a DWDM
CTP.
For CPT 200, CPT 200 SDH, CPT 600, and CPT 600 SDH, a subset of ONS 15454 SONET and
ONS 15454 SDH parameters is supported. The supported parameters match the parameters
associated to the port equipment supported by CPT.
The getAllCurrentPMData interface returns values with a 15-minute granularity if the requested
granularity is 24 hour. For a list of supported layer rates, see
Parameters
Name
Type
Input/
Output
Output
Description
pmTPSelectList
PMTPSelectList_T
In
Specifies which real-time PM data to return.
This list cannot be empty.
This list cannot be empty.