Cisco Cisco Dynamic Fabric Automation for OpenStack Leaflet

Page of 80
What to Do Next
Remove HSRP configurations on border leaf pairs.
Step 9: Removing the HSRP Configurations on Border Leaf Pairs
This step is performed only when there are no Cisco Nexus 5000 Series leafs in the Cisco Dynamic Fabric
(DFA) topology.
Note
During the migration, some hosts learn the anycast gateway MAC address as its MAC address for the default
gateway. Some hosts learn the HSRP Virtual Mac Address (VMAC) as the MAC address for the default
gateway. We recommend that you wait a couple of hours to make sure that the HSRP VMAC address is aged
out on all hosts.
For specific configuration commands and examples, see
.
Note
Before You Begin
You should have completed migration on all leaf switches.
Step 1
Remove the HSRP configuration on each border leaf switch.
Step 2
Change the SVI IP address to the Virtual IP (VIP) address.
After you remove the HSRP configurations, migration is complete.
• You can move to Cisco DFA multicast, if preferred. There is no vPC on the border leaf connecting to
external multicast routers.
• SVIs can be switched to proxy forwarding mode, if preferred.
• New VLANs can be segment-ID enabled.
• In an all-Cisco Nexus 6000 Series topology, you can move to Cisco DFA multicast, if preferred.
Cisco Dynamic Fabric Automation Migration Guide    
   OL-31503-01
27
Migration Steps
Step 9: Removing the HSRP Configurations on Border Leaf Pairs