Cisco Cisco 1 GHz GainStar Node Installation Guide
4042027 Rev A
Balancing and Setup
3-15
Balancing the Reverse Path, Continued
3
Is the reverse output tilt within ±0.5 dB of the design tilt?
a) If the output tilt is within ±0.5 dB of the design tilt, proceed to the next
section.
b) If the output tilt is more than the design tilt, replace the reverse
EQ with a
lower value.
c) If the output tilt is less than the design tilt, replace the reverse
EQ with a
higher value.
4
Measure the output tilt again, and then proceed to Setting OMI for Reverse
Path Transmitter (on page 3-16)
Path Transmitter (on page 3-16)
Note: The reverse equalizer is installed at the factory with 0 dB pad.