Cisco Cisco 1 GHz GainStar Node Installation Guide
Chapter 2 Installation and Configuration
14
OL-31947-02
Attaching the Coaxial Connectors
To Prepre the Mini Node Module for Connector Installation
Complete the following steps to trim longer pins.
1 Loosen the RF connector bolts.
1 Loosen the RF connector bolts.
2 The GainStar Mini Node requires pin-type connectors for all RF connections. The
5/8’’ RF connector will be needed for pins extending 33 mm to 35 mm (1.3 in. to
1.4 in). The PG11 RF connector will be needed for pins extending 29 mm to 31
mm (1.1 in. to 1.2 in). You must trim longer pins before inserting them into the
housing. If the center conductor pin extends beyond the STRIP line on the
housing, trim the pin flush to the STRIP line. The following diagram shows a
visual guide of the center conductor trim length.
1.4 in). The PG11 RF connector will be needed for pins extending 29 mm to 31
mm (1.1 in. to 1.2 in). You must trim longer pins before inserting them into the
housing. If the center conductor pin extends beyond the STRIP line on the
housing, trim the pin flush to the STRIP line. The following diagram shows a
visual guide of the center conductor trim length.