Cisco Cisco 1 GHz GainStar Node Installation Guide
Chapter 2 Installation and Configuration
28
OL-31947-02
If you are not reinstalling the transmitter at this time, proceed to step 11.
If you are reinstalling the transmitter now, proceed to step 7.
7 Insert the transmitter in the slot and ensure that the transmitter is seated
properly.
Note: Insertion slot is labeled on the cover.
Note: Insertion slot is labeled on the cover.
8 Use a flat-blade screwdriver to tighten the mounting screw.
9 Route the fiber pigtail through the fiber retainer clips.
9 Route the fiber pigtail through the fiber retainer clips.
Note: Route excess fiber loosely through the fiber retainer clips.
CAUTION:
Be careful not to damage the fiber or pigtails.
10 Reconnect the fiber connector to the fiber bulkhead.
11 Insert the AC shunt power directors (line power) or plug in the power plug
11 Insert the AC shunt power directors (line power) or plug in the power plug
(mains power). Refer to System Power.
12 Close the housing. Refer to Closing the Mini Node Housing.