Cisco Cisco 1 GHz GainStar Node Installation Guide
Closing the Mini Node Housing
OL-31947-02
33
Closing the Mini Node Housing
To Close the Mini Node Housing
Complete the following steps to close the GainStar Mini Node housing.
CAUTION:
Avoid moisture damage and RF leakage! Follow the procedure
exactly as shown below to ensure a proper seal.
exactly as shown below to ensure a proper seal.
1 Make sure that the housing gaskets are clean and in the correct position. Wipe off
any excess dirt and debris.
2 Close the housing.
3 Lightly secure the six ½-inch closure bolts with a hex driver or ratchet.
4 Using a torque wrench, tighten the six closure bolts to 2.8 Nm.
3 Lightly secure the six ½-inch closure bolts with a hex driver or ratchet.
4 Using a torque wrench, tighten the six closure bolts to 2.8 Nm.
Important: Tighten the closure bolts in the correct sequence as specified in
Torquing Sequence.
Torquing Sequence.
5 Using the same pattern, tighten the housing closure bolts from 6.8 Nm to 9.0 Nm.
Torquing Sequence
The following diagram shows the proper torquing sequence for the housing closure
bolts.
bolts.