Cisco PowerKEY CableCARD Module 802 User Guide
Chapter 1 Set Up the CableCARD or M-Card Module
18
4017453 Rev B
6 Is the Priority value zero?
If yes, click the Priority arrow and select a non-zero value (for example, 3).
Then go to step 7.
Then go to step 7.
If no, go to step 7.
7 Click the Alert Type tab to verify that the Alert Remaining Time field is a non-
zero value.
Note: The value in the Alert Remaining Time field defines the duration of EAS
messages on OpenCable hosts (with and without CableCARD modules).
Note: The value in the Alert Remaining Time field defines the duration of EAS
messages on OpenCable hosts (with and without CableCARD modules).
8 Is the Alert Remaining Time set to zero?
If yes, enter a value (in seconds) greater than zero. Then go to step 9.
Note: Cisco recommends that you type 30 for this field.
Note: Cisco recommends that you type 30 for this field.
If no, go to step 9.
9 Click Save and click Close.
10 Repeat steps 3 through 9 for each unique configuration you have in use.
11 From the Set Up Emergency Alert System Configuration window, click Close.
12 Test the EAS alert functionality to verify that it is working properly.
10 Repeat steps 3 through 9 for each unique configuration you have in use.
11 From the Set Up Emergency Alert System Configuration window, click Close.
12 Test the EAS alert functionality to verify that it is working properly.
Note: Cisco recommends that you test the EAS alert functionality each week.