Cisco PowerKEY CableCARD Module 802 User Guide
Chapter 2 Manage the CableCARD and M-Card Modules
24
4014667 Rev C
5 For further details, refer to the DNCS Online Help for specific steps to add a
CableCARD or M-Card module to the DNCS.
Important! After saving the CableCARD or M-Card module on the DNCS, copy
Important! After saving the CableCARD or M-Card module on the DNCS, copy
protection information should be displayed on the host within a few minutes. If
it is not, contact Cisco Services for assistance.
6 If you are finished, click Exit All CableCARD Screens to close the CableCARD
window.
Editing the CableCARD or M-Card Module and Host in the DNCS
After adding and saving the CableCARD or M-Card module and its associated host
device on the DNCS, you can modify the host ID information and change whether or
not the host is bound to the CableCARD or M-Card module, in order to authorize or
deauthorize the host for copy-protected content.
If you need to modify a parameter other than the CableCARD or M-Card module ID,
If you need to modify a parameter other than the CableCARD or M-Card module ID,
use the following procedure.
1 From the CableCARD Data Summary window, click the corresponding circle in
1 From the CableCARD Data Summary window, click the corresponding circle in
the Select column to choose the CableCARD or M-Card module and host device
that you want to modify.
2 Click Modify Selected CableCARD from the left side of the window. The
Modify CableCARD window opens.
3 Refer to the DNCS Online Help for specific steps to modify the CableCARD or M-
Card module in the DNCS regarding the host ID or the unbind host status of the
CableCARD or M-Card module.
4 When you are finished, click Save CableCARD to save any changes that you
made.
5 Click Exit All CableCARD Screens to close the Modify CableCARD window.